Specific Process Knowledge: Difference between revisions
| Line 141: | Line 141: | ||
==Overview of sample processing 2== | ==Overview of sample processing 2== | ||
{| {{Table}} | {| {{Table}} | ||
|- valign="top" | |||
| | | | ||
{| class="wikitable collapsible" border="1" cellspacing="1" cellpadding="2" align="left" | {| class="wikitable collapsible" border="1" cellspacing="1" cellpadding="2" align="left" | ||
! [[image:cleaning.jpg|thumb|150px|Clean the sample]] | ! [[image:cleaning.jpg|thumb|150px|Clean the sample]] | ||
|} | |} | ||
Revision as of 09:34, 12 June 2014
Feedback to this page: click here
Choose the process topic you are interested in
The section below here is under construction 
Overview of sample processing
Clean the sample 
|
|---|
Drying Samples 
|
|---|
Make a layer on the sample or Film Formation 
| |
|---|---|
| Thermal Oxide growth | |
| Thin Film deposition | |
| Sputter deposition | |
| Thermal deposition | |
| E-beam evaporation | |
| CVD | |
| LPCVD | |
| PECVD | |
| Coating | |
| Spin coating | |
| Spray coating | |
| Electroplating | |
| Epitaxial growth |
Thermal treatment of the sample 
|
|---|
Make a mask on the sample 
|
|---|
| Lithography |
| Imprinting |
| Transfer pattern into the sample |
|---|
| Wet etch |
| Dry etch |
| Lift-off |
| Direct structure definition |
|---|
| Imprinting |
| LASER machining |
| Lithographic definition |
| Polymer Injection molding |
| Bonding samples together |
|---|
| Characterize the sample |
|---|
| Back end of the sample |
|---|
| Chip/die mounting |
| Wire bonding |
| Dicing |
Overview of sample processing 2
|
|
|
| ||||||||||||||||||||||||||||||
|
|
|
| ||||||||||||||||||||||||||||||
|
|