Jump to content

Specific Process Knowledge/Thin film deposition/Si sputter in Wordentec

From LabAdviser

< Specific Process Knowledge | Thin film deposition

Revision as of 14:17, 15 August 2012 by Kn (talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Silicon sputter

Silicon can be deposited in Wordentec.

Parameters

Listed below are tried parameters, that can be used during deposition.

Please don´t use higher power then 180W, since the target then could breake into a lot of small pieces.

	Settings 1	Settings 2
Process type	Sputtering	Sputtering
Power	130W	170W
Sputter pressure	5*10^-2	5*10^-2
Rate	About 0,6Å/s	About 0,6Å/s

Retrieved from "https://labadviser.nanolab.dtu.dk//index.php?title=Specific_Process_Knowledge/Thin_film_deposition/Si_sputter_in_Wordentec&oldid=6405"