Specific Process Knowledge/Thin film deposition/Deposition of Aluminium Nitride

From LabAdviser

Feedback to this page: click here


Deposition of Aluminium Nitride

AlN films can be deposited by sputtering or by atomic layer deposition (ALD).

In the sputter systems AlN can be either deposited by direct sputtering of an AlN target or reactive sputtering with an Al target in mixtures of argon and nitrogen.

Comparison of the methods for deposition of AlN

Sputter-System (Lesker) Sputter-System Metal-Nitride(PC3) ALD2
Generel description
  • Reactive Sputtering ( 2" Al target)
  • Pulsed reactive sputtering
  • Reactive HIPIMS (high-power impulse magnetron sputtering)
  • Plasma Enhanced Atomic Layer Deposition
Stoichiometry
  • AlN
Film Thickness
  • 0nm - 200nm
  • 0nm - 50nm
Deposition rate
  • Not tested
  • 0.0625 nm/cycle on a flat sample
  • 0.0558 nm/cycle on a high aspect ratio structures
Step coverage
  • Very good
  • Very good
Process Temperature
  • Up to 400oC
  • 350oC
Substrate size
  • chips
  • 1x 100 mm wafer
  • 1x 150 mm wafer
  • Several small samples
  • 1 50 mm wafers
  • 1 100 mm wafers
  • 1 150 mm wafer
Allowed materials
  • Silicon
  • Silicon oxide, silicon nitride
  • Quartz/fused silica
  • Photoresist
  • PMMA
  • Mylar
  • SU-8
  • Any metals
  • Silicon
  • Silicon oxide, silicon nitride
  • Quartz/fused silica
  • Al, Al2O3
  • Ti, TiO2
  • Other metals (use dedicated carrier wafer)
  • III-V materials (use dedicated carrier wafer)
  • Polymers (depending on the melting point/deposition temperature, use carrier wafer)

Further process information can be found here: