Specific Process Knowledge/Thin film deposition/Deposition of Gold

4th Level - Comparison

Feedback to this page: click here

Gold can be deposited by e-beam evaporation. In the chart below you can compare the different deposition equipment.

	E-beam evaporation (Alcatel)	E-beam evaporation (Wordentec)	Sputter (Lesker)	Sputter coater Hummer	Sputter coater Balzer
Batch size	Up to 1x4" wafers smaller pieces	24x2" wafers or 6x4" wafers or 6x6" wafers	up to 1x6" wafer	1x4" wafer Several smaller samples	1 large sample (< 4" wafer) Several smaller samples
Pre-clean	RF Ar clean	RF Ar clean	RF Ar clean
Layer thickness	10 Å to 5000Å*	10 Å to 5000Å*	10 Å to
Deposition rate	2 Å/s to 10 Å/s	1 Å/s to 10 Å/s		Not measured	Not measured
Comment	For thicknesses above 200 nm permission is required	For thicknesses above 200 nm permission is required		Used to gold sputter coating of samples mainly before SEM characterization	Used to gold sputter coating of samples mainly before SEM characterization

* For thicknesses above 200 nm permission from ThinFilm group (thinfilm@danchip.dtu.dk) is required.

Adhesion of Au on Si

Adhesion of Au layers

Studies of Au deposition processes

Roughness of Au layers - Roughness of Au layers deposited with different equipment and settings