Specific Process Knowledge/Thermal Process/C2 Furnace III-V oxidation

Feedback to this page: click here

THIS PAGE IS UNDER CONSTRUCTION

III-V Oxidation furnace (C2)

The III-V Oxidaiont furnace (C2) is being use on August 2019 for wet thermal oxidation of III-V devices instead of the III-V ovn, for instance for lateral oxidation of thin AlGaAs layers to defined apertures in light-limiting diodes.

The furnace is an old Tempress horizontal furnace. The quartz boat is loaded manually into the furnace by use of a push rod. The furnace is cooled down to room temperature when it is not being used.

Before use, devices have to be cleaned. A short BHF dip can be used to remove any native oxide which can be difficult to penetrate by a wet thermal oxidation.

Please check the cross contamination information in LabManager before you use the furnace.

The user manual and contact information can be found in LabManager:

III-V Oven (D4)

Process knowledge

• Standard wet oxidation recipe on the III-V oxidation furnace

Overview of the performance of the III-V Oven and some process related parameters

Purpose		Wet oxidation of III-V dvices
Performance	Lateral oxidation rate	Very sample dependent
Process parameter range	Process temperature	420 oC
	Process pressure	1 atm
	Gasses on the system	N2 (bobler) N2
Substrates	Batch size	Several smaller samples (placed vertically on a quartz plate)
	Substrate materials allowed	III-V devices Silicon