Specific Process Knowledge/Etch/Etching of Silicon

Etch of silicon can be done by either wet etch or dry etch. The standard setups for this here at DANCHIP are:

Wet etches:

• KOH etch
• Wet PolySilicon etch

Dry etches:

• Dry etch using RIE1 or RIE2
• Dry etch using ASE

Comparison of KOH etch, wet PolySilicon etch, RIE etch and ASE etch for etching of Silicon

	KOH	PolySilicon etch	RIE	ASE
What is it good for:	Anisotropic etch in the <100>-plan High selectivity to the other plans	Isotropic etch in Silicon and Polysilicon	Can etch isotropic and anisotropic depending on the process parameters Anisotropic etch: vertical sidewalls independent on the crystal plans	As RIE but better for high aspect ratio etching and deep etches (higher etch rate) Good selectivity to photoresist
Possible masking materials:	Silicon Nitride	?	Photoresist Silicon Oxide Silicon Nitride Aluminium Chromium (ONLY RIE2!)	Photoresist Silicon Oxide Silicon Nitride Aluminium
Etch rate			<40nm/min to >600nm/min depending on recipe parameters
Size of substrate	4" and 6" in our standard bath	4" in our standard bath	4" (or smaller with carrier)	6" (when it is set up for 6") and 4" (or smaller if you have a carrier)
Process volume	25 wafers at a time	25 wafers at a time	One wafer at a time	One wafer at a time