Specific Process Knowledge/Characterization/Topographic measurement: Difference between revisions

@@ Line 6: / Line 6: @@
 *Nanoman - ''AFM for measuring nano structures''
+===High Aspect ratio structures===
+The fact that the tip is shaped like a cone with some tip angle causes a problem when characterizing high aspect ratio structures. For instance, if a 20 <math>\mu</math>m wide trench is etched deeper than approximately 18 <math>\mu</math>m, the tip of the Dektak will not be able to reach the bottom. In this case the only solution is to cleave the sample along a line that is perpendicular to the trench and then put it in a [[Specific Process Knowledge/Characterization/SEM: Scanning Electron Microscopy|scanning electron microscope]].
+===Comparing the two profilers and the AFM===
 {| border="2" cellspacing="0" cellpadding="4" align="center"
 !
@@ Line 64: / Line 68: @@
 |-
 |}
-===High Aspect ratio structures===
-The fact that the tip is shaped like a cone with some tip angle causes a problem when characterizing high aspect ratio structures. For instance, if a 20 <math>\mu</math>m wide trench is etched deeper than approximately 18 <math>\mu</math>m, the tip of the Dektak will not be able to reach the bottom. In this case the only solution is to cleave the sample along a line that is perpendicular to the trench and then put it in a [[Specific Process Knowledge/Characterization/SEM: Scanning Electron Microscopy|scanning electron microscope]].