Specific Process Knowledge/Thermal Process/RTP Jipelec 2

Feedback to this page: click here

THIS PAGE IS UNDER CONSTRUCTION

Jipelec - Rapid Thermal Processing

Jipelec RTP: Positioned in cleanroom A-4

January 2021: The RTP Jipelec 2 is not released for use yet

Jipelec JetFIRST 200 RTP (Rapid Thermal Processer/Annealer).

The main purpose of the machine is to anneal different samples very rapidly. Furthermore, the machine can be used for alloying of different materials.

The annealing is done in a process chamber on the machine, in which the samples are heated very rapidly by use of infra red lamps placed in the top of the chamber, directly above the sample. The chamber walls are cooled and remains cold during the annealing.

Samples can be wafers (2". 4", 6" and 8") or smaller samples made of different materials. In the process chamber, the samples are placed on quartz pins, either directly on the pins (only wafers) or on a graphite sucseptor or a Si dummy wafer.

The maximum annealing temperature is 1200 C. For temperatures above 600 C the annealing time is limit as can be seen in the table below.

The temperature is measured by either a thermocouple or an optical pyrometer. The temperature is regulated by a PID controller, thus the PID values will have to be optimized for each susceptor size and for each wafer size and thickness, and it is important to select the right PID table for each process.

Annealing can be done at atmospheric pressure or in vacuum. It is also possible to apply a flow of either nitrogen or argon during the annealing, and forming gas (4 % H₂/96 % N₂) will be connected later.

The user manual, user APV, technical information and contact information can be found in LabManager:

RTP Jipelec 2

Overview of the performance of the Jipelec RTP and some process related parameters

Purpose		RTP annealing
Process parameter range	Process Temperature	0-1200 oC Time limits at temperatures above 700 oC: 700 °C: 60 minutes 800 °C: 30 minutes 900 °C: 20 minutes 1000 °C: 10 minutes 1100 °C: 5 minutes 1200 °C: 1 minute III-V materials to 450 oC Temperature ramp: Up to 50 oC/min with susceptor Up to 100 oC/min without susceptor
	Process pressure	1 atm Vacuum
	Gases on the system	Process gases: N2 Ar Forming gas (4 % H2/96 % N2) - Not connected yet Purge gas: N2 pro
Substrates	Batch size	200 mm wafers (less good temperature uniformity than smaller wafers/samples) 150 mm wafers 100 mm wafers (always placed on a susceptor or dummy wafer) 50 mm wafers (always placed on a susceptor or dummy wafer) Small samples
	Substrate materials allowed	A carrier is always needed: For III-V materials a carbide carrier is used, and for other samples a silicon carrier wafer with 1 µm oxide is used Silicon Silicon oxide and nitride Silicon nitride Fused silica/quartz III-V materials (max 450 oC) - Use a dedicated susceptor Metals - Use a dedicated susceptor and ask for permission