Specific Process Knowledge/Back-end processing/LatticeAxe: Difference between revisions

Revision as of 14:29, 31 March 2020

The Cleaver: Lattice Axe is designed for cleaving wafers into smaller pieces without leaving any particles on the sample. The equipment is placed in the left drawer underneath fumehood 5: Special purposes. When operated the the Cleaver: lattice axe should always be placed inside Fume hood 5.

Approved Materials:

Si
Quartz
Pyrex (Borofloat 33)
GaAs
InP
Sapphire

The LatticeAxe can cleave samples from 100mm down to 10mm. In some cases it can even be used on 150mm samples please contact wetchemistry group for more information

Revision as of 14:07, 31 March 2020 view source Rkch (talk \| contribs) DCH-Employees-701, NLAB-Employees-701, NLAB-LabmanagerAllUsers 271 edits No edit summary ← Older edit		Revision as of 14:29, 31 March 2020 view source Rkch (talk \| contribs) DCH-Employees-701, NLAB-Employees-701, NLAB-LabmanagerAllUsers 271 edits No edit summary Newer edit →
Line 1:		Line 1:
	The Cleaver: Lattice Axe is designed for cleaving wafers into smaller pieces. The equipment is placed in the left drawer underneath fumehood 5: Special purposes. When operated the the Cleaver: lattice axe should always be placed inside Fume hood 5.		The Cleaver: Lattice Axe is designed for cleaving wafers into smaller pieces without leaving any particles on the sample. The equipment is placed in the left drawer underneath fumehood 5: Special purposes. When operated the the Cleaver: lattice axe should always be placed inside Fume hood 5.

	[[File:LatticeAxe placer prøve.JPG\|400px]]		[[File:LatticeAxe placer prøve.JPG\|400px]]