LabAdviser/314/Microscopy 314-307/Postprocessing

THIS PAGE IS UNDER CONSTRUCTION

Available software for post-processing

At DTU Nanolab - building 307/314 you will find a small PC lab where there is access to all the processing and productivity software available at DTU Cen. The lab is located in building 307 room 101. There are four workstations which you can access with your DTU credentials. The following software is installed on all workstations:

Microsoft Office 2016

Digital Micrograph v2 (TEM image processing and analysis)

TIA v4.19 (TEM/STEM image processing and analysis) (ask Cen staff for access)

JEMS v4.3905 (TEM/STEM/Diffraction analysis and simulation)

AZtec v3.3 (SEM and TEM) (EDX spectrum and map analysis)

INCA v5.0.5 (EDX analysis)

Avizo v9.5 (3D rendering)

Additionally, some of the workstations have node-locked licenses to:

PANalytical X’pert Highscore Plus (XRD data analysis): Cen-Himmelbjerg, Cen-Froebjerg, Cen-Valbybakke

Inspect 3D (Tomography reconstruction): Cen-Himmelbjerg, Cen-Froebjerg

TrueImage v2.0.1 (TEM image reconstruction): Cen-Himmelbjerg, Cen-Froebjerg, Cen-Valbybakke, Cen-Yding

Esprit 2.0 (EBSD, TKD and EDS, flatquad and particle analyses): Cen-Himmelbjerg, Cen-Froebjerg, Cen-Valbybakke, Cen-Yding

Additionally, there are two workstations available in the lobby of 314. The same software is installed on these machines. One of these workstations (in front of the ATEM) is specifically made to work with large data sets created with the OneView camera of the ETEM.

Please remember to log out when you have finished your work. Do not turn off the workstations.

Feedback to this page: click here