LabAdviser/Courses: Difference between revisions
| Line 58: | Line 58: | ||
| | | | ||
'''Before the "questions and exercises" session''' | '''Before the "questions and exercises" session''' | ||
* Read Sami Franssila "Introduction to Microfabrication" (2010), Chapter 9: Optical Lithography | * Read [http://onlinelibrary.wiley.com/doi/10.1002/9781119990413.ch9/pdf Sami Franssila "Introduction to Microfabrication" (2010), Chapter 9: Optical Lithography] (Available online from DTU campus). | ||
* Watch the [http://podcast.llab.dtu.dk/index.php?id=302 lecture videos] (7 videos, 2:41 hours in total). Write down any questions that may arise during the videos. | * Watch the [http://podcast.llab.dtu.dk/index.php?id=302 lecture videos] (7 videos, 2:41 hours in total). Write down any questions that may arise during the videos. | ||
'''Before training session''' | '''Before training session''' | ||
* Watch the training videos of spin coating (automatic), exposure (operation, and alignment), and development (automatic). | * Watch the [http://podcast.llab.dtu.dk/feeds/dtu-danchip/ training videos] of spin coating (automatic), exposure (operation, and alignment), and development (automatic). | ||
* Study the equipment manuals. The manuals are available in LabManager. | * Study the equipment manuals. The manuals are available in [http://labmanager.danchip.dtu.dk LabManager]. | ||
* Study the TPT process flows (first print, and alignment). | * Study the TPT process flows (first print, and alignment). | ||
'''Links to literature, lecture videos, training videos, equipment manuals, and process flows can be found in the section below. | '''Links to literature, lecture videos, training videos, equipment manuals, and process flows can be found in the section below. | ||