Specific Process Knowledge/Etch/Etching of Titanium: Difference between revisions
No edit summary |
No edit summary |
||
| Line 44: | Line 44: | ||
|'''Batch size''' | |'''Batch size''' | ||
| | | | ||
1-25 wafers at a time | 1-5 4" in beaker | ||
1-25 wafers at a time in PP-etch bath | |||
| | | | ||
1- | 1-5 4" wafer at a time | ||
|- | |- | ||
|''' | |'''Etch bath''' | ||
| | |Beaker or PP-etch bath in the fume hood in cleanroom 2. | ||
|- | |- | ||
|'''Allowed materials''' | |'''Allowed materials''' | ||
| Line 58: | Line 56: | ||
No restrictions when used in beaker or PP-etch bath in the fume hood in cleanroom 2. | No restrictions when used in beaker or PP-etch bath in the fume hood in cleanroom 2. | ||
| | | | ||
No restrictions when used in beaker. | |||
|- | |- | ||
|} | |} | ||
Revision as of 10:20, 11 February 2008
Etching of Titanium
Etching of Titanium is done wet at Danchip. We have two solutions for titanium etching:
- BHF
- Cold RCA1 (as stripper)
Do it by making your own set up in a beaker in a fume hood - preferably in cleanroom 2 or 4. BHF etching can also take place in the PP-etch bath in the fume hood in cleanroom 2.
Comparing the two solutions
| BHF | Cold RCA1 | |
|---|---|---|
| General description |
Etch of titanium with or without photoresist mask. |
Etch of titanium (as stripper) |
| Chemical solution | HF:NHF | NH3OH:H2O2:H2O - 1:1:5 |
| Process temperature | Room temperature | Room temperature |
| Possible masking materials |
Photoresist (1.5 µm AZ5214E) |
None |
| Etch rate |
Not known (it bubbles while etching) |
Not known |
| Batch size |
1-5 4" in beaker 1-25 wafers at a time in PP-etch bath |
1-5 4" wafer at a time |
| Etch bath | Beaker or PP-etch bath in the fume hood in cleanroom 2. | |
| Allowed materials |
No restrictions when used in beaker or PP-etch bath in the fume hood in cleanroom 2. |
No restrictions when used in beaker. |
