Specific Process Knowledge/Etch/DRIE-Pegasus/Pegasus-2/TemperatureSettings: Difference between revisions
Created page with " 400px | frameless" |
No edit summary |
||
| (4 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
'''Feedback to this page''': '''[mailto:labadviser@nanolab.dtu.dk?Subject=Feed%20back%20from%20page%20http://labadviser.nanolab.dtu.dk/index.php/Specific_Process_Knowledge/Etch/DRIE-Pegasus/Pegasus-2 click here]''' | |||
<!--Checked for updates on 28/6-2023 - ok/jmli --> | |||
<!--Checked for updates on 4/9-2025 - ok/jmli --> | |||
{{contentbydryetch}} | |||
==Correct settings for temperatures on Pegasus 2 == | |||
The Platen chiller temperature is enabled and the setpoint is 20 degrees as seen in the image below. This setting could be applied to all the heaters, however, the best way by far is to run the processes without enabling the heaters as seen for the other heaters. | |||
[[file:Peg2tempsettings.jpg | 400px | frameless]] | [[file:Peg2tempsettings.jpg | 400px | frameless]] | ||
