Specific Process Knowledge/Thin film deposition/MVD

The contents on this page, including all images and pictures, was created by DTU Nanolab staff unless otherwise stated.

Feedback to this page: click here

The Molecular Vapor Deposition tool

The MVD is located in cleanroom A-1

The Applied Microstructures MVD 100 system deposits molecular films on surfaces. These films serve a wide range of purposes ranging from antistiction coatings of nanoimprint lithography stamps to protecting MEMS structures. At DTU Nanolab the MVD is an essential tool for nanoimprint lithography, where it is used to create antistiction coatings on the imprint stamps.

The user manual, user APV, and contact information can be found in LabManager:

MVD in LabManager

Process information

• Processing on the MVD
• The FLAT recipe
• The STAMP recipe

Equipment performance and process related parameters

Purpose		FDTS coating of Si or SiO2 surfaces Indirect O2 plasma treatment
Vapor sources	Line 1 2 3 4	Chemical Water FDTS (new source, 2013) FDTS (old source, contaminated line) Available (line probably contaminated, no source heater)
Performance	Contact angle	110° (water)
Process parameters	Base pressure	20 mTorr
	Chamber temperature	35°C
	Chamber volume	Approx. 3 liters
Substrates	Substrate size	1" to 8" Smaller samples may be processed if fixed to a carrier
	Allowed materials	All cleanroom materials except steel and other ferrous materials
	Batch	One sample at a time Two 4" or 6" wafers may be processed simultaneously using cassettes