Specific Process Knowledge/Etch/IBE⁄IBSD Ionfab 300/IBE magnetic stack etch: Difference between revisions
| (13 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
==Etching magnetic stacks | '''Feedback to this page''': '''[mailto:plasma@nanolab.dtu.dk?Subject=Feed%20back%20from%20page%20http://labadviser.nanolab.dtu.dk/index.php/Specific_Process_Knowledge/Etch/IBE%E2%81%84IBSD_Ionfab_300/IBE_magnetic_stack_etch click here]''' | ||
<br> '''''The work on this page was done Kristian Hagsted Rasmussen, DTU Nanolab, unless otherwise stated''''' | |||
=Etching magnetic stacks= | |||
Magnetic stacks can be etched or more precisly milled in the Ion Beam Etcher (IBE). Below is presented some work done on milling stacks of magnetic layers. | Magnetic stacks can be etched or more precisly milled in the Ion Beam Etcher (IBE). Below is presented some work done on milling stacks of magnetic layers. | ||
==Results of Design of Experiments optimization of magnetic stack etching ( | |||
==Results of Design of Experiments optimization of magnetic stack etching (Kristian Hagsted Rasmussen@nanotech.dtu.dk spring 2011)== | |||
===Process parameters=== | ===Process parameters=== | ||
| Line 64: | Line 68: | ||
|- | |- | ||
|} | |} | ||
<br clear="all"/> | |||
===Some SEM profile images of the etched stacks=== | ===Some SEM profile images of the etched stacks=== | ||
| Line 84: | Line 89: | ||
===Problems with resists stripping | ===Problems with resists stripping after etching=== | ||
Resist stripping after the etch can be hard due to burned resist, to remedy this try to lower the current. Changing the | Resist stripping after the etch can be hard due to burned resist, to remedy this try to lower the current. Changing the current will change the sidewall angle and new studies of etch profiles will be necessary. For help, discussion and further info please contact the dry etch group [mailto:dryetch@nanolab.dtu.dk]. | ||
===Design of Experiment results=== | ===Design of Experiment results=== | ||
| Line 100: | Line 104: | ||
* Good end point detection by SIMS. | * Good end point detection by SIMS. | ||
* Burned resist: Lower current, 300 mA can limit resist burning. Note this <b>will</b> affect pattern transfer. | * Burned resist: Lower current, 300 mA can limit resist burning. Note this <b>will</b> affect pattern transfer. | ||
* Hare ears due to redeposition, thinner resist can limit the size. | * Hare ears (also called fences) due to redeposition, thinner resist can limit the size. | ||