Specific Process Knowledge/Thin film deposition/thermalevaporator

THIS PAGE IS UNDER CONSTRUCTION

Feedback to this page: click here

Thermal evaporator- A system for deposition of metals

Positioned in cleanroom A-1.

The main purpose for the thermal evaporator is to deposition of Al for removing charging of the restsit when doing EBL on isolerede substrate.

It is no only usable for Al deposition. The thermal evaporator have room for two boats and there by the possibility to make thinfilms of two different metals. At the moment not that many metals have been test and made a recipe for. Right now is is only Al and Ag that can be used.

The user manual, APV, technical information and contact information can be found in LabManager:

Thermal Evaporator in LabManager

Process information

Materials for thermal evaporator evaporation

• Aluminium
• Silver

Equipment performance and process related parameters Alcatel

Purpose	Deposition of metals and silicon	Thermal evaporation of metals
Performance	Film thickness	10Å - 1µm* (for some materials)
	Deposition rate	0.5 Å/s - 5 Å/s (material dependens)
Process parameter range	Process Temperature	Approximately room temperature
	Process pressure	Low than 4*10-6 mbar
Substrates	Batch size	Up to 8" wafer Or several smaller pieces Deposition on one side of the substrate
	Substrate material allowed	Silicon wafers Quartz wafers Pyrex wafers
	Material allowed on the substrate	Silicon oxide Silicon (oxy)nitride Photoresist PMMA Mylar Metals

* For thicknesses above 200 nm permission is requested.