Specific Process Knowledge/Etch/DRIE-Pegasus/picoscope: Difference between revisions

From LabAdviser
Jump to navigation Jump to search
No edit summary
Line 39: Line 39:
|-
|-
|}
|}
When running any recipe on theSPTS Pro software  
When running any recipe on the SPTS Pro software, a set of process parameters are recorded (defined in the logging recipe that can be modified like any other recipe) as the process runs. This data can be accessed later by looking up the datalog. During the process itself, one can also activate the 'Trace' to monitor the process parameters in real time.
Using the SPTS Pro soft
 


<gallery caption="4 cycles of Process A " widths="400" heights="500" perrow="2">
<gallery caption="4 cycles of Process A " widths="400" heights="500" perrow="2">

Revision as of 15:12, 17 March 2020

Feedback to this page: click here

Process optimization using the Picoscope

The original standard recipes on Pegasus 1 differ in many ways. The second step of one of them is listed below:

Process A Step 2 parameters
Parameter Etch Dep
Gas flow (sccm) SF6 350 (1.5 s), 550 C4F8 200
Cycle time (secs) 7.0 4.0
Pressure (mtorr) 25 (1.5 s), 150 25
Coil power (W) 2800 2000
Platen power (W) 140 (1.5) 45 0
Common Temperature 20 degs

When running any recipe on the SPTS Pro software, a set of process parameters are recorded (defined in the logging recipe that can be modified like any other recipe) as the process runs. This data can be accessed later by looking up the datalog. During the process itself, one can also activate the 'Trace' to monitor the process parameters in real time.



4 cycles of the recipe PrD4 recorded with the Picoscope
4 cycles of the recipe PrD4 recorded with the SPTS software
4 cycles of the recipe Prcocess A recorded with the Picoscope
4 cycles of the recipe PrD4 recorded with the SPTS software