Specific Process Knowledge/Etch/Etching of Platinum

Feedback to this page: click here

Etching of Platinum

Etching of Platinum can be done either by wet etch or by sputtering with ions.

• Etching of Platinum by wet etch
• Sputtering of Pt

Comparison of Platinum Etch Methods

	Pt wet etch	IBE (Ionfab300+)
Generel description	Wet etch of Pt	Sputtering of Pt
Etch rate range	~?nm/min	~30nm/min (not tested yet)
Etch profile	Isotropic	Anisotropic (angles sidewalls, typical around 70 dg)
Masking material	None (only used for stripping Pt)	Any material that is allowed in the chamber, photoresists included
Substrate size	Any size and number that can go inside the beaker in use	Smaller pieces glued to carrier wafer #1 50mm wafer #1 100mm wafer #1 150mm wafer #1 200mm wafer
Allowed materials	No restrictions cross contamination wise as long as you use the right beaker and make sure that they are safe to enter in the chemicals	Silicon Silicon oxides Silicon nitrides Metals from the +list Metals from the -list Alloys from the above list Stainless steel Glass III-V materials Resists Polymers Capton tape