LabAdviser/314/Microscopy 314-307/TEM/ETEM/OneView

Set dose calibration for OneView

Set dose calibration for OneView camera in Digital Micrograph

Here are a few information on the OneView camera and the control in GMS3:

1. Go to "Customs" and "SetDoseCalibrationTag_OneView_mod-DTU"

Run script

2. Type in the high tension the microscope is running in the pop-up window

Select high tension

3. Don't change the conversion factor; just click on "OK"

Don't change conversion factor

Feedback to this page: click here