Specific Process Knowledge/Thin film deposition/Si sputter in Wordentec: Difference between revisions
No edit summary |
No edit summary |
||
| Line 6: | Line 6: | ||
'''Parameters''' | '''Parameters''' | ||
Listed below are tried parameters, that can be used during deposition. | Listed below are tried parameters, that can be used during deposition. Use the rates as a start value, and make a test to be sure that you get the right thickness. | ||
Revision as of 15:18, 15 August 2012
Silicon sputter
Silicon can be deposited in Wordentec.
Parameters
Listed below are tried parameters, that can be used during deposition. Use the rates as a start value, and make a test to be sure that you get the right thickness.
Please don´t use higher power then 180W, since the target then could breake into a lot of small pieces.
| Settings 1 | Settings 2 | |
|---|---|---|
| Process type | Sputtering | Sputtering |
| Power | 130W | 170W |
| Sputter pressure | 5*10-2 | 5*10-2 |
| Rate | About 0,6Å/s | About 0,6Å/s |