LabAdviser/Courses/TPT Lithography: Difference between revisions

Revision as of 20:53, 25 November 2019

Feedback to this page: click here

DTU Nanolab offers a Tool Package Training in Lithography; the course includes theory on lithographic processes and equipment, as well as training in equipment operation and processing in the cleanroom.

The course is for all users that intend to perform any kind of lithographic processing in the cleanroom, and is a prerequisite for training in other lithography equipment.

Lithography Tool Package Training
Schedule	Theoretical part Lecture videos that can be viewed at one's leisure. A 1 hour "questions and exercises" session 2 times a month (typically Fridays 09:30-10:30). Sign up via Q&E session Doodle Practical part A 3-4 hour training session 2 times a month, max. 4 persons per session (typically Wednesdays 09:00 - 12:30 or 10:00 - 13:30). Sign up via Training session Doodle
Location	Theoretical part The location of the "questions and exercises" session is room 121A in building 345C. Practical part The training session takes place inside the cleanroom. The meeting point will be in front of the first equipment.
Qualified Prerequisites	Cleanroom safety course at DTU Nanolab Admission to the cleanroom must be obtained before the training session Theoretical part must be completed before the training session.
Preparations	Before the "questions and exercises" session Read Sami Franssila "Introduction to Microfabrication" (2010), Chapter 9: Optical Lithography (Available online from DTU campus). Watch the lecture videos (7 videos, 2:41 hours in total). Write down any questions that may arise during the videos. Before training session Complete the theoretical part (Q&E) Watch the training videos of spin coating (automatic), exposure (operation + alignment), and development (automatic). Study the equipment manuals. The manuals are available in LabManager. Study the TPT process flows (first print + alignment). Links to literature, lecture videos, training videos, equipment manuals, and process flows can be found in the section below.
Course Responsible	The Lithography Group at DTU Nanolab lithography@nanolab.dtu.dk. Sign up for the course using Doodle (links under schedule).
Learning Objectives	Describe fundamental parts of lithographic processing in a cleanroom, design of process flows Authorization to use spin coater, mask aligner, and developer at DTU Nanolab Calculate relevant process parameters Analyze and apply your results of lithographic processing

Material for preparations and further information

Literature

Lecture videos
7 videos, 2:41 hours in total

Lecture slides

Training videos
On YouTube:

On DTU Podcasts:

Manuals

Automatic Spin Coater: Spin Coater: Gamma UV
UV Mask Aligner: Aligner: MA6 - 2 or KS Aligner
Automatic Puddle Developer: Developer: TMAH UV-lithography

Process Flows

@@ Line 62: / Line 62: @@
 !Course Responsible
 |
-The Lithography Group at DTU Danchip [mailto:lithography@danchip.dtu.dk lithography@danchip.dtu.dk].
+The Lithography Group at DTU Nanolab [mailto:lithography@nanolab.dtu.dk lithography@nanolab.dtu.dk].
 Sign up for the course using Doodle (links under schedule).
@@ Line 71: / Line 71: @@
 |
 * Describe fundamental parts of lithographic processing in a cleanroom, design of process flows
-* Authorization to use spin coater, mask aligner, and developer at DTU Danchip
+* Authorization to use spin coater, mask aligner, and developer at DTU Nanolab
 * Calculate relevant process parameters
 * Analyze and apply your results of lithographic processing