Specific Process Knowledge/Etch/AOE (Advanced Oxide Etch)/Remove resist in the AOE

• Feedback to this page: click here

Unless otherwise stated, this page is written by DTU Nanolab internal

Remove AZ resist in the AOE using the recipe Descum

Parameter	Descum (also setting for TDESC10M 20241029)
Coil Power [W]	2000
Platen Power [W]	30
Platen temperature [oC]	0
O$_{2}$ flow [sccm]	99
Pressure [mTorr]	10.0 (strike pressure 20.0 mTorr)

Typical results	tested by bge@nanolab
AZ resist etch rate	~41 nm/s

BARC etching

I have tried once etching BARC with recipe SiO2_res:

Parameter	Recipe: SiO2_res	Recipe: Barcetch
Coil Power [W]	1300	400
Platen Power [W]	200	100
Platen temperature [oC]	0	0
He flow [sccm]	174	0
C$_{4}$F$_{8}$ flow [sccm]	5	0
CF4 flow [sccm]	0	4
H$_{2}$ flow [sccm]	4	20
Pressure [mTorr]	4	1
Etch rate in BARC [nm/sec]	2	1
Selectivity to DUV resist [Barc:resist]	?	[1-2:1]